How to do a urine drug test? (Multiple Drugs) (Panel)
Step 1
SETUP
Before you start you will need a timer (timer on your phone or watch is fine) and a clean container to collect the urine sample.
Collect a urine sample in a clean cup or container.
Remove the drug test panel from the foil wrapper.
STEP 2
PERFORM
Take the cap off the drug test panel to expose the prongs.
Dip the prongs into the urine sample for 10-15 seconds, so that they absorb the urine.
Remove the drug test kit from the urine sample, lay it flat and set your timer going for 5 minutes.
STEP 3
RESULTS
After 5 minutes you can read the results.
Check for control lines in all the results columns.
If control lines are not observed on all windows on the drug test kit, wait a further 5 minutes for the test to complete, any test windows without a control line are invalid after 10 minutes.
A POSITIVE drug test result (ie drugs have been detected) will show only a control line and no test line at 10 minutes.
A NEGATIVE drug test result (ie no drugs detected) will show both a control line and a test line as early as 5 minutes.
An INVALID drug result will have no control line visible at 10 minutes. The most common reason for an invalid result, on a urine drug test, is inadequate urine being absorbed. If this occurs simply dip the prongs back into the urine sample for a further 15-20 seconds or until you see a pinkish discoloration running up the prongs.
Subscribe to our emails
Be the first to know about new drug testing products and exclusive offers.
Choosing a selection results in a full page refresh.